Benefits of installing vacuum equipment on woodworking CNC engraving machine

In the production of some woodworking enterprises, woodworking engraving machines produce a large amount of sawdust powder. Therefore, using vacuum cleaner equipment for woodworking engraving machines has great advantages. It can avoid the pollution of wood CNC router, etc., and is also conducive to the use of wood CNC router. Only then can normal maintenance and upkeep work be carried out. At the same time, physical harm to the operator can be avoided.

First of all, when choosing an engraving machine, be sure to choose an CNC router  with dust-proof and dust-removing devices. Because it can absorb a lot of dust generated during the engraving process at any time during the engraving process. Even so, there will still be a certain amount of dust in the air, so we recommend that operators wear protective glasses and dust masks when working to protect their eyes and respiratory organs and prevent dust injuries.

In addition, the vacuum cleaner plays an important protective role during the working process of the woodworking engraving machine, so we recommend that customers equip the machine with a vacuum cleaner. On the one hand, it can keep the surrounding environment hygienic, on the other hand, it can better protect the wood CNC router. The operator himself must also take appropriate protective measures. Installing a vacuum device can not only extend the service life of the engraving machine, but also save you time in maintaining the engraving machine.

The daily maintenance of the dust-proof device of the woodworking CNC engraving machine is as follows:

First of all, check and remove all kinds of chips and other dirt on the surface every day to prevent the accumulation of debris, check whether the running track meets the lubrication requirements, and prevent damage caused by huge friction due to insufficient lubricating oil. Look at the surface. Whether it is very smooth and whether there are scratches, as a basis for early detection, these problems should be checked again before leaving get off work in the afternoon. These tasks are the focus of every day, and we hope to attract everyone's attention.

Secondly, the main content of regular inspections is to inspect the dust cover of the engraving machine mechanism to prevent dust and abrasive particles from adhering to the surface of the cooling tube. If these things exist, it will affect the service life and working accuracy of the screw and cause product damage. If it is unqualified and the screw guard is found to be damaged during inspection, it should be repaired in time. When the damage is serious, it should be replaced in time. After each work, drain the remaining water in the water tank and wipe it with a dry cloth. machine.